TEST & MEASUREMENT APPLICATION NOTES AND WHITE PAPERS

• Characterization Of An Amplifier With The Combination Of Network And Spectrum Analysis

  The general characterization of complex DUTs such as amplifiers requires the measurement of several parameters. Thanks to its versatility, the R&S^® ZNL is an economic solution that can characterize a variety of DUTs both via network analysis and spectrum analysis.

• Harmonic Measurement For IEC 61000-4-3 And Other Radiated Immunity Standards

  Amplifiers exhibiting significant harmonic distortion in immunity test systems can exhibit broadband characteristics that result in measurement uncertainty and unacceptable errors. This app note addresses acceptable harmonic measurement standards and other radiated immunity standards.

• Understanding Component EMC Testing for ICs

  If you're producing integrated circuit (IC) products for electromagnetic environments, you must test and pass all the regulatory electromagnetic interference (EMI) and safety requirements. Electromagnetic compatibility (EMC) testing is performed to ensure these components can be used in the intended environment without failing, degrading, or causing other equipment to fail.

• Circuit Models For Plastic Packaged Microwave Diodes

  This paper reports on the measurement and establishment of circuit models for SOT-23 and SOD-323 packaged diodes. Results indicate that the 1.5 nH estimate for the SOT-23 is a useful result, as is 1.2 nH for SOD-323 single packaged diodes. It was also determined that the effective inductance of the SOT-23 may be reduced to approximately 0.4 nH by adding a second bond wire and modifying the microstrip line. Other lead configurations, including parallel bond wires and common cathode configurations, were also studied.

• Accurately Measure Your UWB Device's Time Of Flight

  The R&S®CMP200 radio communication tester together with the R&S®CM-Z300A time of flight kit provides an accurate setup for time of flight measurements – in validation, calibration and certification.