-
Millimeter Wave Subharmonic Mixers: MSH Series
8/28/2012
The MSH Series of millimeter wave subharmonic mixers are ideal for heterodyne radiometer applications, instrumentation, automated test equipment, and for frequency extension to 193 GHz.
-
Image Reject, IQ, And Single Sideband Mixers
3/30/2012
Marki Microwave’s image reject, IQ, and single sideband mixers offer superior performance and are built to the same standards as their catalog mixers.
-
Broadband RF, Microwave, And Millimeter Wave Mixers
3/30/2012
Marki Microwave has a variety of circuit lines of Broadband RF, Microwave, and Millimeter Wave Mixers.
-
Harmonic Mixers
6/21/2007
The HHM series broadband harmonic mixers cover full waveguide bands from 18 – 110 GHz. They utilize a low loss finline structure mated to a GaAs Schottky beam lead diode for minimum conversion loss and maximum bandwidth
-
High Linearity/IP3 Mixer For Intermodulation Distortion Suppression: T3
3/28/2012
The T3 (Two-Tone-Terminator) High Linearity/IP3 Mixer was developed by Marki Microwave to address intermodulation distortion suppression in modern military and commercial RF/Microwave systems. It features low conversion loss (<7 dB), unparalleled IMD suppression, a high 1dB compression point, and more. It’s based on the most sophisticated mixer circuit technology commercially available today.
-
High Linearity Differential IF Mixers
11/22/2010
The RFMX0015 and RFMX1015 high linearity differential IF mixers operate in the standard cellular bands between 600 to 1050 MHz and 1500 to 2200 MHz respectively and support both high and low-side LO injection for IF frequencies up to 300MHz. In addition, the mixers feature an IF bias pin that enables users to reduce the DC current to save power when peak linearity performance is not required.
-
GaAs MMIC I/Q Mixers
4/6/2013
These GaAs MMIC I/Q Mixers are ideal for applications involving point-to-point radio, point-to-multi-point radio, sensors, military radar, satellite communications, EW, and ELINT. Two different models are available in this series with frequency range coverage of 24-28 GHz, and 8-12 GHz.
-
Millimeter Wave General Purpose Harmonic Mixer: MHP Series
8/28/2012
Millitech’s Millimeter Wave General Purpose Harmonic Mixer is ideal for applications involving signal processing, phase-lock loops, EW/ELINT, and spectrum analyzers/frequency counters. They’re low cost, and feature full waveguide bandwidth, high sensitivity, and low conversion loss.
-
Millimeter Wave Biasable Balanced Mixers
8/28/2012
Millitech’s line of millimeter wave biasable balanced mixers are ideal for applications involving receiver subsystems, test equipment, broadband downconverters, and EW/ELINT. Two different series of mixers are available. The MXB biasable mixers are not recommended for new designs. See the MB1 series datasheet below for an updated line of millimeter wave biasable mixers.
-
Wideband Mixers
3/30/2011
Wideband Mixers from Lansdale Semiconductor, Inc.
