Custom RF

PRODUCTS

  • Used 10 cu ft Patterson Kelly twin shell blender, stainless steel construction, rated 62#/cu ft maximum material density, provision for high speed intensifier bar(less car and capped off) with 5 hp motor, shell driven by 1 hp, 230/460 volt motor drive, on stand, serial# 301460. Missing cover, cover tie down bars and bottom outlet valve.

  • The Holzworth HX4920 Frequency Divider is a digital divide-by-4 architecture covering input signals of 4GHz to 24GHz while maintaining signal integrity. 

  • The AMP2074P-LC-8KW pulse amplifier is designed for Pulse/HIRF, EMC/EMI Mil-Std 461/464 and Radar applications, providing superb pulse fidelity 1.0-2.5GHz, 10KW Typical and up to 100usec pulse widths.

  • The Hach TSS Portable Hand-held Turbidity, Suspended Solids, and Sludge Blanket Level Instrument's unique multi-beam alternating light method with infrared diode system gives it a broad measuring range for both turbidity and suspended solids in one portable handheld instrument.

  • When it comes to your capsules, cleanliness is key. That’s why this revolutionary polisher guarantees that all areas of the polisher are easy to clean. The one-piece cylindrical polishing chamber promotes powerful, cyclonic air flow ensuring continuous movement and ease of cleaning.

WHITE PAPERS AND CASE STUDIES

NEWS

ABOUT

Custom RF

Custom RF Designs have become commonplace today when just a few years ago custom RF was the realm of large conglomerates with deep research pockets. The tools to conduct customized RF projects are plentiful and are easily obtainable online as well as almost any electronic shop in the neighborhood. Electronic components are a commodity now and chips, resisters, capacitors and any component that is needed to complete a circuit board for any function can be found anywhere.

These custom RF circuits can be built to power anything from a radio control airplane whether controller unit can be built from scratch as well as the receivers The RF module can be purchased too and just added to the custom project. It is also possible to build custom controllers for TV and remote alarm systems. The RF portion is just a control module with a simple interface that allows remote operation.

Custom RF projects are usually initiated by customers who can’t find a readymade module in the market for a specific project. A case in point would be the RF module for a swimming pool filtration system. The custom RF module would have to be water tight and the entire module be protected from steam as well as water. The physical box would have to be customized. However, the operational aspects can be customized too. There are numerous reasons for this and almost all requirements can be accommodated with today's technology. Most companies tend to custom make their devices to fit their various needs.