Product Showcase

  1. Full Ka-Band Omnidirectional Antenna: SAO-2734030810-KF-S1
    9/18/2018

    SAGE Millimeter offers the new SAO-2734030810-KF-S1 full band omnidirectional antenna for 5G, communications, and EW applications in the 26.5 to 40 GHz frequency range. This is a vertically polarized antenna with 360 degrees azimuth coverage and a 7.5 dBi typical gain and ±1 dB nominal gain flatness.

  2. 8.5 – 10.5 GHz GaN T/R Module: QPM1002
    9/17/2018

    Qorvo introduces the new QPM1002 GaN MMIC front-end module (FEM) designed specifically for X-band radar applications in the 8.5 – 10.5 GHz frequency range. Combining a T/R switch, low-noise amplifier, and a power amplifier, this device delivers a small signal gain of 33 dB, delivers 3 W of saturated power, and 25 dB of large signal gain.

  3. Multi-Band, High Precision GNSS Antennas: ANN-MB Series
    9/17/2018

    The u-blox ANN-MB series of multi-band active GNSS antennas are designed to support signals on the L1 and L2/L5 bands of the four key global navigation satellite constellations (GPS, GLONASS, Galileo, and BeiDou).

  4. 3400 – 3600 MHz Thermally-Enhanced High-Power RF GaN On SiC HEMT: GTRA364002FC
    9/17/2018

    Wolfspeed’s new GTRA364002FC is a thermally-enhanced high-power RF GaN on SiC HEMT designed for multi-standard cellular power amplifier and other wireless infrastructure applications in the 3400 – 3600 MHz frequency range. The device features an output power of 400 W, 13 dB gain, and operation at 48 V.

  5. 7.5 – 18 GHz TWT Amplifier: dB-3911
    9/11/2018

    The dB-3911 power-combined TWT Amplifier (TWTA) uses two wideband, periodic permanent magnet (PPM)-focused TWTs to amplify CW, AM, FM or pulse-modulated signals. Compared to a single TWT approach, the dB-3911 provides higher saturated output power and improved harmonic performance.

  6. RADOX® Cable Technology
    9/5/2018

    HUBER+SUHNER’s RADOX®, or “radiation X-linked” technology, describes the process of crosslinking thermoplastic polymers by means of electron beams. This technology is used to improve the thermal, mechanical, and chemical properties of cable insulation materials. RADOX® cables do not melt, possess better abrasion resistance and greater cut resistance than conventional cables and, even with thinner insulation, are much more resistant to various environmental factors.

  7. 4.4 – 5.0 GHz GaN Power Amplifier Module: QPA4501
    9/4/2018

    Qorvo’s QPA4501 is an integrated 2-stage Power Amplifier (PA) module designed to cover the frequency range of 4.4 to 5.0 GHz. This device is optimized for 5G massive MIMO, W-CDMA/LTE, macro and micro cell base station, active antenna, and other general purpose applications.

  8. 2.4 GHz Wi-Fi/BT/LTE Co-Existence BAW Filter: QPQ1907
    9/4/2018

    Qorvo’s QPQ1907 is a high-performance, high power Bulk Acoustic Wave (BAW) band-pass filter designed to enable coexistence of WiFi and LTE signals within the same device or in close proximity to one another. This device is ideally used in WiFi/Bluetooth, consumer premise equipment (CPE), small cells, and smart meter applications.

  9. 100 W Ka-Band TWT Amplifier With Rackmount Configuration: dB-4164
    9/4/2018

    dB-Control offers the dB-4164 traveling wave tube amplifier (TWTA) for power amplification of CW, AM, FM or pulse-modulated signals. Operating in the 26.5 to 40 GHz frequency range, this TWTA provides 100 Watts minimum output power, and proprietary low-noise, high-efficiency designs to operate the RF signal path.

  10. Mixed Signal Oscilloscope (MSO): 6 Series
    8/29/2018

    Tektronix offers the 6 Series Mixed Signal Oscilloscopes (MSO) designed for present and future troubleshooting and high-speed design validation applications within the 1 – 8 GHz frequency range. This series provides accurate measurements, low noise, and 25 GS/s sample rates per channel.