TEST & MEASUREMENT APPLICATION NOTES AND WHITE PAPERS

  • Four Practical Applications Using An Electronic Load

    This article presents four tips on how to test with electronic loads and illustrate the flexibility and usefulness of a DC electronic load. 

  • Combining On-Wafer VNA And Spectrum Analyzer Measurements

    This app note describes how S-parameters and spectrum analysis can be monitored simultaneously from 70 kHz to 110 GHz using the VectorStar ME7838A, the Spectrum Master MS2760A, and the Anritsu MN25110A W1 coaxial precision directional coupler.

  • VCO Measurements With FSPN Phase Noise Analyzer

    This application note provides a short technical introduction to voltage-controlled oscillators and explains the most common and the most important measurements made during the VCO characterization process.

  • De-Embedding Test Fixtures For High-Speed Digital Applications

    Test fixtures are commonly used in high-speed digital measurement to connect devices to measurement equipment. Characterization and analysis in time and frequency domains help remove the influence of these fixtures.

  • Linearity Of The JFET And MOSFET When In Saturation Over The Entire Cycle

    Performing RF amplification in a way that is simultaneously linear and efficient has been a challenge in power amplifier (PA) design. Single transistor PAs can either be operated in a linear, but inefficient, current source mode of operation or as efficient, but nonlinear, switches. These techniques use two FETs, but this paper demonstrates that linear amplification can be achieved at high power with an efficiency greater than 60%, using a single FET.

TEST & MEASUREMENT SOLUTIONS

Qorvo introduces the QPC2040 single-pole, double-throw (SPDT) switch operating within the 8 – 12 GHz frequency range for commercial and military radar, communications, electronic warfare, test instrumentation, and other general purpose applications. The switch typically supports 10 W input power handling at control voltages of 0/−2 V for both CW and pulsed RF operations.

The EVO-RSA-6070A is part of the EVO Series of extended frequency spectrum analyzers from Avcom designed for higher performance and agility in applications with continuously changing requirements. The included SDR-style technology analyzer includes a wide bandwidth receiver and employs FPGA, DSP, and high-performance processors.

The Model 6350S is a small form factor 8-channel A/D & D/A subsystem designed for a variety of applications including high-bandwidth data streaming, waveform signal generators, multimode data acquisition, and other electronic warfare systems. Designed to be integrated into larger systems with minimal design effort, the 6350S delivers the performance and high-channel density of RFSoC in a small, convenient footprint.

Producing a system that excels in performance and reliability is easy when you have System Design and Applications Engineers with years of experience, Customer Service with global reach, and products that are known for performance and quality. AR has this very organization and product offerings. AR is here for you at each step to ensure that the system design, integration, and support of your EMC or RF system complies with your goals.

The Si894x is a galvanically isolated delta-sigma modulator which outputs a digital signal proportional to the voltage level at the input. 

Qorvo offers the 1800 W, 65 V, 1.0 – 1.1 GHz QPD1025L as the highest GaN transistor on the market. This discrete GaN on SiC HEMT has a package that features input pre-match resulting in ease of external board match and saved board space.

The dB-9001 from dB Control is a custom-mounted Instantaneous Frequency Measurement (IFM) unit designed to operate in the C, X, and Ku-band frequency range and provide highly accurate measurements at 100 ns to CW pulse width measurements.

The SMS7630 Series comprises low-cost, surface mountable, plastic packaged silicon mixer Schottky diodes designed for RF and microwave mixers and detectors. They include low barrier diodes and zero-bias detectors that combine Skyworks advanced semiconductor technology with low-cost packaging techniques. All diodes are 100 percent DC tested and deliver tight parameter distribution, which minimizes performance variability.