Product/Service

High-Power CW/Pulsed RF Amplifier

Source: Aethercomm

High-Power CW/Pulsed RF Amplifier
Aethercomm Model Number SSPA 0.35-0.50-1000- RM is a high power CW or pulsed RF amplifier that operates from 350 to 500 MHz in a rack mounted configuration. This rack mount product is capable of operation from VHF to UHF in bands.

Click Here To Download:
High-Power CW/Pulsed RF Amplifier - Datasheet

This amplifier has a typical output power of 1000 watts at P3dB, and offers a typical small signal gain of 65 dB with a typical gain flatness of ± 0.5dB. Input and output VSWR is 2.0:1 maximum. This RF rack mounted amplifier operates from 230VAC, 3 phase power but can be configured to operate from any AC voltage specified. There are forward and reflected power RF sample ports.

The output is fully protected from an infinite VSWR at the RF output port. The input RF connector is type N Female. The output RF connector is a 7/16's female. The RF sample ports are SMA female. There is a RF enable switch on the front panel of the amplifier. Contact the factory with any questions on the performance or capabilities of this amplifier. There is a complex thermal management system to cool the internal circuitry.

Features:

  • Operation from 350 MHz to 500 MHz min
  • 1000 Watts Peak Output Power Typical
  • 230 VAC, 3 Phase Operation
  • Multiple BIT and Protection Features on Rack

Click Here To Download:
High-Power CW/Pulsed RF Amplifier - Datasheet