Product/Service

LNFA1X4: Low Noise, Filtered, Amplified 1X4 GPS Antenna Splitter

Source: GPS Networking

LNFA1X4: Low Noise, Filtered, Amplified 1X4 GPS Antenna Splitter

The LNFA1X4 Low Noise Filtered Amplified GPS Splitter is a one-input, four-output device with 0 dB nominal gain. The device features a low noise input section to establish an overall system noise figure. Excellent port-to-port isolation and unity gain are achieved by padded outputs

Contact The Supplier

Click Here To Download:
Datasheet: LNFA1X4: Low Noise, Filtered, Amplified 1X4 GPS Antenna Splitter

The LNFA1X4 Low Noise Filtered Amplified GPS Splitter is a one-input, four-output device with 0 dB nominal gain. The device features a low noise input section to establish an overall system noise figure. Excellent port-to-port isolation and unity gain are achieved by padded outputs. The device features excellent frequency selectivity around the L1 band to prevent interference from other high power radio frequency sources, such as cellular transmitter stations. The LNFA1X4 device will power itself and an external GPS antenna from a 5.0 VDC source connected on any of the RF Outputs. A “hunt-and-pick” circuit is used to select only one DC input for power in the event that more than one source is connected. Remaining DC inputs are switched to a 200O resistor to simulate antenna current draw.

Features

  • Unity Gain -- ± 1dB
  • High Isolation Outputs -- > 45 dB Port-to-Port Isolation
  • Low Noise Figure -- < 4 dB

Click Here To Download:
Datasheet: LNFA1X4: Low Noise, Filtered, Amplified 1X4 GPS Antenna Splitter

Need More Information? Just Ask.

Click the button below to directly contact the supplier. Use it to:

  • Ask a question.
  • Request more detailed information or literature.
  • Discuss your current project/application.
  • Request a quote.
  • Locate a distributor in your area.
  • Schedule a demo.
Contact The Supplier