Featured Products
|
Low-Profile Bandpass Filter
K&L Microwave offers a low-profile bandpass filter that is suitable for applications where cable connections are necessary while maintaining a "z" dimension that is comparable to many surface-mount applications.
• Download Datasheet
•
Request Information
|
 |
|
WCS/MMDS Air Cavity Diplexer
This diplexer from ComNav Engineering uses TE mode waveguide puck resonators to achieve narrowband filters of less than 0.25% bandwidth yet still provide a passband loss on the order of <1.5 dB. Cross coupling is used to achieve very deep rejection of 75 dBc at a 4:1 shape factor.
• Download Datasheet
•
Request Information
|
 |
|
Analog Noise Generators
The UFX7000A series instruments from Noise Com provide broadband Gaussian noise with superior flatness. The output power can be attenuated up to 127 dB in 1-dB steps. Several connector types are available.
• Download Datasheet
•
Request Information
|
 |
|
Electronic Attack Subsystems
Cobham Sensor Systems has developed and deployed electronic attack subsystems on multiple fixed-wing and ground mobile vehicles. Its equipment provides cost-effective solutions to interrupt and defeat the operation of enemy radar and communication systems.
•
Request Information
|
 |
|
RF Design Suite
CST Design Studio speeds up the analysis and optimization of complex or highly resonating structures. Its open architecture enables the user to combine results from the best sources available in one user-friendly environment.
•
Request Information
|
 |
|
Low-Noise, Filtered, Amplified 1 X 4 GPS Antenna Splitter
The LNFA1X4 low-noise, filtered, amplified GPS splitter from GPS Networking is a one-input, four-output device with 0-dB nominal gain. The device features a low-noise input section to establish an overall system noise figure.
• Download Datasheet
•
Request Information
|
 |
|
Very-Low-Power, Miniature OCXO
Greenray Industries, Inc. now offers the ZYH1002/1003 series OCXO. The ZYH1002/1003 series miniature reference oscillators offer a new low-power option designed specifically for use in applications that require low power consumption and/or battery power.
• Download Datasheet
•
Request Information
|
 |
|
Tissue-Simulating Liquid For SAR Measurement
This product from NTT can be applied for SAR measurement in cellular phones, measurement of radiation patterns, and development of receiving and transmitting antennas used near a human body. The product is ecological, doesn't smell, and has a small temperature dependency of dielectric properties.
•
Request Information
|
 |
|
4- To 8-GHz Octave Band Amplifiers
Ciao Wireless offers a broad selection of octave band and half-octave band amplifiers. All amplifiers feature integral voltage regulators that make performance insensitive to supply voltage variations over a nominal 12- to 20-Volt DC voltage variation...
•
Request Information
|
 |
|
Low-Noise Pre-Amplifiers For MRI
e2v designs and manufactures a range of coil pre-amplifiers for magnetic resonance imaging (MRI). In addition, diode protection (in anti-parallel diode pairs) is included on the input and output for immunity from the high-level RF excitation pulses in the host MRI system.
• Download Datasheet
•
Request Information
|
 |
|
Electric And Magnetic Field Analyzer
The E-H fields analyzer model EHP-200 from Narda Safety Test Solutions has been designed for accurate isotropic measurements of both electric and magnetic fields in the 9-kHz to 30-MHz frequency range, with no or minimum perturbation of the fields that are being measured.
• Download Datasheet
•
Request Information
|
 |
|
125-Watts CW, 6- To 600-MHz RF Power Amplifier
Manufactured at AR Modular RF, model KAW2120 is a Class AB, wideband, RF power amplifier delivering in excess of 125-watts CW power into a 50-Ohm load over the frequency range of 6 MHz to 600 MHz.
•
Request Information
|
 |
|
Dual Databus Interface Transformers
Designed to move data at rapid speed in rugged environments, the low-profile 4256-1003 series dual databus interface transformers from Datatronics feature a space-saver surface-mount package for high-density electronic equipment.
• Download Datasheet
•
Request Information
|
 |
|
Millimeter-Wave Device Characterization Systems
The MT900N family of millimeter-wave device characterization systems from Maury Microwave provides a set of characterization tools for the development of circuit design methodologies that extract increased performance from a given fabrication process by enhancing transistor operating range and linearity.
• Download Product Overview
•
Request Information
|
 |
|
Cooling Filters
Cooling Filters from W. L. Gore & Associates enable the use of direct air cooling by providing critical contamination protection, allowing you to take full advantage of the natural thermal efficiency of ambient air.
• Download Datasheet
•
Request Information
|
 |
|
OCXO
The OCXO 100 from Precision Devices features an operating temperature range of -40 to + 85 degrees C (with other options available). Standard use of an OCXO includes controlling various frequencies for test and measurement applications, military communications equipment and radio transmitters, and base stations.
• Download Datasheet
•
Request Information
|
 |
|
Diplexers And Multiplexers
Diplexers are three-port devices that are used to combine or split signals that are at different frequencies. A diplexer is designed with two fixed bandpass filters that are connected to a common port. Multiplexers are passive devices used to split or combine signals, usually of different frequencies.
• Download Datasheet
•
Request Information
|
 |
|
HF Inductors, Transformers, And Tapped Coils
Coil-Q offers customizable HF inductors, transformers, and tapped coils for magnetic and electrostatic shielding applications. All products are RoHS compliant.
• Download Spec Sheet
•
Request Information
|
 |
RSS
